Knowledge Base

Configure VLAN on a PtP Link

In this example, you should first refer to Configure a Layer-2 Point-to-Point Link , referring to the following link

The network and IP setting is showing below

Radio 1 (Access Point) Setting

Radio 2 (Station WDS) Setting


  • The IP address of VLAN2 is due to customer’s configuration. If no need of pinging that VLAN, the IP could leave blank.

  • The station VLAN setting should be same with the AP VLAN setting except the radio IP address

  • Use the untagged VLAN id at wireless settings, then all the tagged packets can pass through the ptp link