Connecting with Mikrotiks base station
Before the connection, make sure the Mikrotiks TDMA protocol is turned off like below.
If the nstreme or nv2 is enabled, only Mikrotiks devices can connect to each other.
1) Use winbox, setting the Mikrotiks device IP address to 192.168.1.1, work as bridge mode.
2) Setting the wireless
3) Setting WDS if required
4) At last, at the CPE side, scan signal and choose the ssid 'Mikrotiks', input the encryption key, apply and save settings.
5) Check connection in status page and done.