Knowledge Base

Configure a Layer-2 Point-to-Point Link



These instructions assume that your radio is set to FACTORY DEFAULT values.  Please restore to factory defaults before proceeding.  

1.First, set your computer's wired network with static IP of 192.168.1.x (x should be any one of  100~254, such as 192.168.1.100). This computer is used to setting the radios.
2.Using a web browser, enter 192.168.1.2 as the "URL" to gain access to the radio's management console.

Enter "admin" as the administration account and "admin" as the password.


For radio WIS-Q2300(2)

a) Go to Network page, and click VLAN Interface, then click the edit button.

b) After pop-up the window, input the IP address following below instruction, then click "Apply"

c) The software would re-direct you to the new IP page, use "admin" as username and password to login, and go to wireless page.

d) Go to Radio page, choose the Wireless Mode as "Access Point WDS". Apply and save.

AP WDS.png

e) Go to Wireless page, choose Enable at Wireless Availability , and press Apply & Save after finishing the SSID and encryption settings.

For radio WIS-Q2300(1)

a) Go to Radio page, choose the Wireless Mode as "Station WDS". Apply and save.

station WDS.png

b) Go to Wireless page, press Scan. Wait for showing the signal ,then click the SSID or the MAC address. Press apply and save.

c) The Main page would show up the current connection condition. You can check for signal strength or throughput graphic.